Go Back OFN Forums > Fabrication > Fabrication 101

Fabrication 101 Everyone has to start somewhere and for some, theOFN might be that somewhere.


Fabrication 101 Everyone has to start somewhere and for some, theOFN might be that somewhere.

Reply
 
Thread Tools
  #1  
Old 03-13-2017, 10:50 PM
Rastus's Avatar
Rastus Rastus is offline
Master Fabricator
 
Join Date: Sep 2006
Location: San Antonio, Texas
Posts: 115
Welding Critique

How do these look? I keep making small adjustments to the settings, but I never really get the sizzle sound. aka bacon frying.

Welder is a Eastwood Mig 175.







thanks..
__________________
Fame is vapor, popularity an accident, riches take wings. Only one thing endures and that is Character.
Rockkrawler.org
Reply With Quote
  #2  
Old 03-14-2017, 11:23 AM
entropy's Avatar
entropy entropy is offline
Master Fabricator
 
Join Date: Sep 2007
Location: 95-miles from the center of Oregon.
Posts: 8,331
...sitting here, drinking a cup-a-Joe, for the most part things look acceptable,
but it also looks like there is a slight bit of under-cutting which could be
heat or wire or hand technique... I'd try bringing the wire speed up a little and
see if that gets you into the bacon.

E
__________________
When did empirical knowledge get replaced by a theoretical education?

Reply With Quote
  #3  
Old 03-19-2017, 01:45 AM
310kick's Avatar
310kick 310kick is offline
Junior Fabricator
 
Join Date: Apr 2009
Posts: 27
I would start by removing the rust and making sure the metal is clean. You will see a difference for sure. Are you dragging the gun in a straight line? If so practice on making a C pattern remembering to stay on the front edge of the puddle.
Reply With Quote
  #4  
Old 03-19-2017, 07:33 PM
wyoming9's Avatar
wyoming9 wyoming9 is offline
Master Fabricator
 
Join Date: Aug 2008
Location: New Tripoli Pa. out in the woods
Posts: 2,198
Red face

If you leave the voltage alone slowing turn up the wire speed till it bounces off the puddle.

then slowly back off to it quits

Those welds are just a little on the to hot side either voltage to high or wire speed to slow

I really never hear the frying bacon unless it is someone else

I always wear ear plugs one spark hitting my ear lobe was enough

Then just what size wire are you running .023 ??
__________________
Some days it takes longer to pick which welder

then to do the welding
Reply With Quote
  #5  
Old 07-16-2017, 05:02 PM
LaWay's Avatar
LaWay LaWay is offline
Junior Fabricator
 
Join Date: May 2017
Location: WestCenLa
Posts: 1
Always grind to shiny metal before welding, and have a good ground. I too noticed a little undercut on the edges. New welders tend to look at the light but always look at the puddle forming just behind and to the sides to make sure its filling in.
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:55 AM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Template-Modifications by TMS
Copyright 2012, Offroad Fabrication Network