Go Back OFN Forums > Fabrication > General Fabrication

General Fabrication Any Fab that does not fit into another Forum


General Fabrication Any Fab that does not fit into another Forum

Reply
 
Thread Tools
  #1  
Old 03-07-2016, 05:15 PM
Gotlift's Avatar
Gotlift Gotlift is offline
Fabricator
 
Join Date: Apr 2009
Location: Rio Rancho, NM
Posts: 67
F-250 Prerunner Bumper

Definitely learned a few things on this build. I should have put the mounting brackets 1"-1.5" further away from the bumper. I cut them a little short, which changed my bend points on the main bar. I intended to lay the bar on and then mark my bend points on the outside of the mounts, but they were too close to the bumper and I didn't have a straight shot between the mounts. I then had to bend the bar on the inside of the brackets to make it fit. It didn't necessarily change the look much, but I would do that different next time. I still need to gusset the mounts.

All in all, I think it turned out okay. I just need to mount some lights. I'll most likely sell this one and turn out another one.





Reply With Quote
  #2  
Old 03-11-2016, 04:28 PM
dkr_diego's Avatar
dkr_diego dkr_diego is offline
Fabricator
 
Join Date: Oct 2013
Location: La Serena, Chile
Posts: 89
Nice Job!!!
Reply With Quote
  #3  
Old 03-11-2016, 09:19 PM
310kick's Avatar
310kick 310kick is offline
Junior Fabricator
 
Join Date: Apr 2009
Posts: 27
Looks clean and you didn't have to drill your bumper.
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:27 PM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Template-Modifications by TMS
Copyright 2012, Offroad Fabrication Network