Looking to ditch my HF Air over Hydro on the tube bender and go full hydro.
I have a handful of elcetric motors, I believe they're Baldor .75HP / 1HP / 1.5HP and maybe a 2HP. Going to guess the hydro pump will dictate which one I need to use, and that leads to my question... and likely speed.
What hydraulic pump everyone is using, and will not bend way too fast.
I want it to be faster than the air over hydro FOR SURE just not OMG there goes 30*
The plan is going to be to make this eventually have quick connects so I can use it for shop press too
If I need to get a bigger motor then I get a bigger motor :)
2.5" x 24" RAM or what to hit 90* with the model 3 without re-pinning?
Would like to be able to bend 2.00 x .250 DOM if I needed too (can go slow, and I know is risky busting the bender itself) but NEVER regularly. Most of the tube will be 1.75 x .120 and some 2.0 x .120 DOM, might do some 1.5 x .250 rarely too.
EDIT: Just noticed a BENDING forum, this can be moved :)