View Single Post
Old 09-27-2006, 03:23 PM
TheBandit's Avatar
TheBandit TheBandit is offline
Instagram @chevyhotrodder
Join Date: Jan 2006
Location: Ventura County CA
Posts: 4,407
Originally Posted by fabcam
It looks to me like the notches were way off and he used welding wire to fill the gap.
I noticed that in this picture, but don't see that in the others.

Below Is this a bad weld because the edges of the weld are not smooth into the adjoining metal? In other words, is it a cold weld?

Below What do you see in this picture that looks bad? I can't see anything wrong with this one.

Below In this picture it looks like he ground too far into the welds, such that as you follow the OD of the tube toward the joint, there is a dip. Am I correct?

Reply With Quote