View Single Post
  #248  
Old 03-27-2017, 02:22 PM
juicedz4's Avatar
juicedz4 juicedz4 is offline
Master Fabricator
 
Join Date: Jan 2011
Location: Rochester, NY
Posts: 519
Wasnt digging the dumb bends on the input lines at the firewall so I picked up some nickel plated bulkhead 90s. It turned out SO much better.







With that done, I whipped up the rear crossover line and bracket. Im still deciding on what to use for clamps, hence its just floating right now.
There will be no hard line on the drivers side, the braided line from the caliper will just extend right to the tee.







And hose routing on the pass side around the surge tank and thru the axle beam





Finally, I was able to work out routing of the ebrake cables without getting crazy and completely re-routing them. I just need the next size longer, 1800mm vs 1730mm. They are on order. I had to do a small notch in the fuel filter bracket (still needs a tiny bit more clearance) and massaged the corner of the gas tank a bit to add a small channel.









Dan
Reply With Quote