View Single Post
  #194  
Old 08-25-2016, 09:19 AM
CarterKraft's Avatar
CarterKraft CarterKraft is offline
Master Fabricator
 
Join Date: Oct 2009
Location: DFW
Posts: 894
Quote:
Originally Posted by juicedz4 View Post
Itll be like anything else that once you have it you find (make) more reasons to use it.

Dan
That's pretty much my reasoning for everything in the shop.


SwageLok says the following about their bender.

Quote:
"Cannot be used for 2507 tubing over 1/4 in. or for medium-pressure tubing."
2507 seems to be some Stainless Alloy "Duplex stainless steel is comprised of austenite and ferrite in an approximate 50/50 split. Super Duplex 2507 is a highly alloyed, high performance advanced form of this material."

Medium pressure is a thin walled stainless tube.

Quote:
"Medium-Pressure Tubing FK Series
Cold-drawn 1/8-hard tubing is more robust and allows for reduced wall thickness and enhanced flow through the same diameter tube. All Swagelok medium-pressure tubing is marked to indicate size, material, condition, and heat number.

Specifications
Heavy-Wall Annealed
Material 316/ 316L stainless steel
Pressure Rating 15 000 psig (1034 bar)
Sizes
1/4 in. OD, 0.095 in. wall

3/8 in. OD, 0134 in. wall

1/2 in. OD, 0.188 in. wall
Cold-Drawn 1/8-Hard
Material
316/ 316L stainless steel
Pressure Rating
15 000 psig (1034 bar)
Sizes
1/4 in. OD, 0.065 in. wall

3/8 in. OD, 0.083 in. wall

1/2 in. OD, 0.109 in. wall"

Where does NiCop fit into this?

Last edited by CarterKraft; 08-25-2016 at 09:22 AM.
Reply With Quote