View Single Post
  #65  
Old 06-05-2015, 01:55 AM
juicedz4's Avatar
juicedz4 juicedz4 is offline
Master Fabricator
 
Join Date: Jan 2011
Location: Rochester, NY
Posts: 519
Finished up the tiptisserie the last couple nights. I had to make some adapters for the OE bumper supports to bolt to the 2x6s which took some time. It also took some adjusting of the plywood 1/4 circles to be able to tip it up by myself. Its still pretty hard to get up to 45 degrees, but after that its easy. I think If I just shorten the legs a little that might be enough. Anyway, its up now. I did put a tie down to the wall just for extra safety, but its very stable.





Dan
Reply With Quote