View Single Post
  #16  
Old 10-25-2013, 02:46 PM
Graham08's Avatar
Graham08 Graham08 is offline
Master Fabricator
 
Join Date: May 2006
Location: Iron Station, NC
Posts: 1,800
A few shots of the rear suspension with the car on the ground...

Right rear:



Left rear:



Right side wishbone bracket:



The small loop is to push things out to where the wishbone is clear of the body. The next set of wishbones might have sphericals in the front pivot instead of a rod end, just to do away with the shank in bending. But, there isn't that much bending load here since the brakes are inboard, and the torque tube reacts the drive torque.

An overall side view:



The "starter"...when a truck is pushing on it :



Reply With Quote