View Single Post
  #9  
Old 03-18-2010, 05:27 PM
Black Pearl's Avatar
Black Pearl Black Pearl is offline
Master Fabricator
 
Join Date: Feb 2010
Location: Houston, TX
Posts: 264
I'll post a picture of mine when I get over to my buddies shop. I turned it down to 1" in the mounting shaft and made it 2.25" long so it has a small flange to weld to on 2x4" tubing , put a 1.00" radius on the sphered end, then I milled the pockets 0.50" deep on each side and milled a 1" hole. Total length is 5.00" if I remember correctly.

I'll post the g-code if I can get my buddy to d/l it out of the lathe.
Reply With Quote