Thread: 3" tubing bend
View Single Post
  #7  
Old 03-02-2011, 10:03 PM
fabcam's Avatar
fabcam fabcam is offline
Site Admin
 
Join Date: Aug 2004
Location: MN
Posts: 4,567
Quote:
Originally Posted by mikefrombc View Post
sounds like your are building a OIF type frame , where are you located ?? i,ll check tomorrow to see what size CLR our 3" die set is we may be able to provide you with that piece to your specs .
You could also make 45 degree bend, push the tube a few inches and then make another 45 degree bend if the radius was smaller than requested. Not the same but may work.
__________________
The Designers of Bend-Tech Products
www.Bend-Tech.com
Bend-Tech Dragon web site:
http://www.BendTechDragon.com

Cris Merry
Phone: 651-257-8715
Cris@bend-tech.com

Reply With Quote